How To Relight Pilot Light On Rheem Water Heater Guide 2022. Turn heat to low turn the temperature knob on the outside of the unit to the lowest setting. You can get replacement parts on amazon if you need them.
Help, My Water Heater Is Scaring Me! Plumbing DIY Home from www.diychatroom.com
If you’re going on extended vacations, you should turn off the pilot light. Push down the red button to the left of the gas knob. Use a flashlight to see the small parts and lettering on the water heater.
Table of Contents
Follow The Instructions That Came With Your Wall Heater To Light The Pilot Light.
Use a flashlight to see the small parts and lettering on the water heater. It will be a small, blue flame located near the burner on the front of the unit. You can get replacement parts on amazon if you need them.
Push Down The Red Button To The Left Of The Gas Knob.
Also remove the inner heat shield panel. Remove front panels find the metal access panel under the knobs near the bottom of the heater and remove it. Turn heat to low turn the temperature knob on the outside of the unit to the lowest setting.
Rotate The Gas Knob Of Your Rheem Water Heater Clockwise Until It Reaches The “Off” Position.
If you’re going on extended vacations, you should turn off the pilot light. Turn off the wall heater by switching off the breaker that it is plugged into. Pilots of rheem water heaters need to manually be lit using the piezo igniter striker that is built into the water heater.
Push Down The Red Button To The Left Of The Gas Knob.
The traditional gas igniter is a standing pilot, and in the past, you had to light it by hand using a long match.contemporary richmond water heaters have sealed combustion chambers, though, so if they have standing pilots, they are equipped with piezoelectric spark igniters.before trying to relight the pilot, consult your owner's manual to make sure that there is.
Skip to content
